M
M
M
E
E
E
R
R
R
C
C
C
U
U
U
R
R
R
Y
Y
Y
U
U
U
S
S
S
E
E
E
R
R
R
M
M
M
A
A
A
N
N
N
U
U
U
A
A
A
L
L
L
49
45 10*10 dithering
A-2 Manual Color Fill Mode
Each power and speed setting can be linked to certain color on the layout. Totally 16 color
settings are available. The desired color can be adjusted by changing the ratio of Red, Green
and Blue. If the speed or power is set to 0, the corresponding color area or vector line will be
invalid.
A-3 3D Mode
With this function, we can get the sculpture effect. The engrave image must have gray levels.
The engrave image is effected by PPI, DPI, power and speed setting.
3D Image File
Sample/ Material: Density Board
A-4 Stamp Mode
Mainly used in rubber stamp production. Create a slope base of stamp characters by setting
up the
stamp parameter
. Normally the pitch number for engraving a 2~3mm thick rubber pad
can be set at 0.2 or 0.3. The smaller the pitch number is, the sharper the slope is. If setting the
pitch number at a very big value, it may take for a very long time for the math calculation.
