M
M
M
E
E
E
R
R
R
C
C
C
U
U
U
R
R
R
Y
Y
Y
U
U
U
S
S
S
E
E
E
R
R
R
M
M
M
A
A
A
N
N
N
U
U
U
A
A
A
L
L
L
53
Stamp
Production
You may wish to create a full sheet of duplicated rubber stamps in order to have
them all engraved at once, saving on material costs and operation time. To do
this, copy and paste the image to the full page which is smaller or equivalent to
the working table and the rubber sheet. Next make sure that the image is
mirrored, inverted and that the appropriate shoulder, border, power and speed
settings are in place.
B. Parameter Settings
The LaserPro Mercury allows the use of 16 different colors to represent 16 different power and
speed settings when cutting and engraving. These colors are referred to as PENS. Try to
think of each pen as a designated laser setting, rather than as a color. An image that is only
black and white will use only one power and speed laser setting (Black). An image that
includes black, red and blue colors will use three different assigned power and speed settings.
In order to utilize up to 16 different pens, make sure your graphics program uses the 16 colors
recognized by the driver.
B-1 Pen Settings
There are 16 available pen settings to match a specific laser setting with the different colors
used in the graphic image. If your image uses black outlines, and red and blue color fills, then
the driver will instruct the laser to use three different power and speed settings on the three
Adjust speed / power for each pen
Check to enable or disable raster / vector / power ramp for each pen
