M
M
M
E
E
E
R
R
R
C
C
C
U
U
U
R
R
R
Y
Y
Y
U
U
U
S
S
S
E
E
E
R
R
R
M
M
M
A
A
A
N
N
N
U
U
U
A
A
A
L
L
L
58
C-3 Image Output Direction
Top to Bottom –
The laser would engraver from top to bottom of the image.
Bottom Up –
Normally, the LaserPro Mercury engraves from top to bottom, left
to right. Selecting Bottom Up will force the machine to start from the bottom and
work its way to the rear of the working table. Some laminates will produce dust that
may get lodged in the engraved area if the machine engraves from top to bottom.
Since the exhaust system is located at the rear of the machine, the dust will be
sucked away from the engraved area.
C-4 Vector Setting
All Raster Output –
When choose “all raster output” to print graphic including
vector line and raster image, the laser would take the vector line as raster data
and print the whole graphics as raster engraving image.
Vector sorting —
When your image has one vector cut area enclosing another
vector cut area, this setting will automatically direct the laser to cut out the inside
enclosure before moving to the outside image.
Optimization –
This is another setting that will automatically cut down on operation
time. When selected, the EXPLORER driver will analyze your image and find
the most efficient passing route to complete the job.
C-5 Cluster
To reduce the working time needed for multiple productions, this setting may be used. Let’s
take multiple stamp production for example. When selected, the driver will automatically
determine the fastest method to engrave more than one stamps. The laser may complete
one stamp before starting another or may undertake several stamps at the same time. Adjust
