18
Power supply
▪
The detector is powered by a 9V alkaline
battery.
Mounting the staff clamp
▪
Insert the staff clamp screw into the staff
clamp thread.
▪
Rotate the nut until the clamp is secured
in place.
Battery replacement
▪
Remove the battery door cover.
▪
Insert the battery according to polarity and
replace the battery door.
USING YOUR DETECTOR
Detector operation
▪
Switch the detector on by pressing the
power button. The speaker will beep once
indicating the instrument is operating.
▪
The LCD screen will display the battery
level, detection mode and speaker function.
▪
To change between coarse and fine mode
press the coarse / fine mode button
▪
Move the detector into the path of the laser
beam.
▪
Hold the detector upright for horizontal
beams. Rotate the detector 90° for vertical
beams.
▪
The direction arrows or level line on the LCD
screen will indicate the position of the laser
beam. The detector will emit a constant beep
once the level position has been located.
Summary of Contents for HV2G
