1 0
rolls should turn back. The controller frame has to be advanced in front
of the hinged loading chute edge so that the attendant stops the
loading rolls or let them turn back at pushing the frame by leg!
-
It is strictly forbidden to change or to set the controller frame so that the
STOP position is under the loading chute edge.
-
While chipping it is not allowed to enter the area of ejected flying wooden
chips.
-
The end piece of the discharge duct can be set only in the angle up to 60
o
to longitudinal axis (upper turnable part) opposite to the loading chute. Do
not direct it toward the attendant's place.
-
While working the chipper should rest on supporting legs on the loading
side and be braked by means of its parking brake. If uncoupled from a
towing vehicle it should be based on its front wheel. Travel wheels should
be slightly unloaded by lowering of the front wheel.
-
It is forbidden to let stand the chipper on its travel wheels only while
chipping.
-
Keep this machine beyond children's and unauthorised person's reach.
Avoid their attendance while chipping.
-
When using the chipper without any container or closed bin, keep anybody
beyond the area where chips are thrown.
-
When using the chipper with such a bin, never look inside if the chipper is
still working.
-
When leaving the machine take always the switch key out of ignition.
-
Every operator of this machine is fully responsible for any injury or damage
caused to the third persons within the operating reach of the machine.
-
At work in residential zones use the machine in accordance with
regulations of the local authorities to avoid disturbing of local inhabitants
(noise, flying chips).
-
Warning!!! Be aware of ejected particles. They have substantial kinetic
energy. If the loaded wooden material contains not allowed parts, such as
metal, sand, glass etc., then such objects can reach a longer distance
than wooden chips. Therefore direct the discharge duct in order to regulate
ejecting.
-
Instructions for use of the engine operation and the trailing truck are an
integral part of this manual.
While chipping the operator is obliged:
o
to use only such a chipper which is in optimal operating condition, not
damaged through transport, storage or from previous operation,
o
to check functions of all controls and safety elements before putting the
chipper into operation,
Summary of Contents for LS 150 D
Page 1: ...OPERATING INSTRUCTIONS CHIPPER LS 150 D LS 150 DW Version 06 2010...
Page 5: ...5 EC Conformity Declaration...
Page 6: ...6...
Page 7: ...7...
