Chipper LS 160T
33
Recommendations:
Do chipping at rated PTO shaft speed only, i.e. at
sufficient power of the chipping wheel for ejecting chips.
Being loaded short and fine materials may deposit or clog
the space behind the loading rolls in front of the chipping
wheel. To avoid such problems and clogging put
occasionally also some longer branches.
To prolong service life of blades never put any materials
with parts of impurities, such as of metal, glass, ceramics
and other similar objects.
Optimal sharp blades reduce operating costs of the
loading and chipping equipment (reduced wear of the
chipping device).
If loaded material is free of any impurities then a grinding
interval for blades may last several months or several
hundreds m3 of loaded materials.
Blunt blades are evident on chipped edges which are not
clean but broken.
The chipper is optionally equipped with its speed regulation and the NOSTRESS
system intended particularly for tractors with power less than 30 HP.
This regulator reduces material feeding upon contingent overloading (PTO shaft
speed dropping).
The chipping wheel speed is set by the manufacturer to 900 (1100) rpm to turn the
rolls off and to 910 (1110) rpm to turn the rolls on again.
Recommendations!!
Should the loading rolls be frequently turned off while chipping,
it means that there is too much material loaded and the chipping
device is overloaded. To avoid this overloading:
reduce volume of material to be loaded, or
reduce infeed speed of the loading rolls
Summary of Contents for LS 160
