TERMO-VIOLA
49
The panel enables stove lighting and shutdown, adjustment during operation and the setting of management and
maintenance programmes.
The display shows all the information on stove operation status.
To access the menus, proceed as follows:
-
press the SET button ‘P3’;
-
press the button
s ‘P5’,‘P6’ repeatedly to scroll the various menus;
-
press one of the increase/de
crease buttons ‘P1’, ‘P2’, to set the required parameter;
-
press the SET button ‘P3’ to confirm the parameter value.
On accessing the menu it is possible to obtain the various types of displays and carry out the available settings
depending on the access level.
Given below is the table of controls and respective messages displayed during programming or setting operation
parameters:
The Figure opposite describes the meaning of the status
indicators in the left part of the display.
Activation of one of the segments on the display signals
activation of the corresponding device according to the list
opposite.
4.3
Lighting
4.3.1 Check before lighting
Before lighting the stove:
- make sure you have read and understood that given in the manual;
- the hopper must be filled with pellets;
- the combustion chamber must be clean;
- the brazier must be completely free, cleaned of any combustion residuals and correctly fitted in the brazier
holder;
- check hermetic closing of the fire door and ash pan;
External contact
Chrono
Electrical element
Auger
Fume extractor
DHW circuit activation
HEATING circuit activation
ALARM
Decrease output or the DHW boiler water thermostat
Temperature value (if enabled)
Increase output or the DHW boiler water thermostat
Temperature value (if enabled)
Decrease output or the DHW boiler water thermostat
Temperature value (if enabled)
Increase output or the DHW boiler water thermostat
Temperature value (if enabled)
Increase
temperature
Decrease
temperature
Setting/menu
ON/OFF
reset
Decrease
power
Increase
power
TEMPERATURE
SETTING
PROGRAMMING
PROGRAMMING
PROGRAMMING
TEMPERATURE
SETTING
WORK
WORK
WORK
WORK
WORK
Increases the room and water thermostat temperature value
Increases the selected parameter
Displays temperatures
Decreases the room and water thermostat temperature value
Decreases the selected parameter
Displays stove operation status
Access the temperature SETTING and user and technician
parameters menu by successive pressing
Press for 2 seconds to switch the stove on or off (if off or on)
Exits the programming menu at any point of modification.
The changes are saved
Resets the stove and returns it to off status
BLOCK
Button
Description
Mode
Action
Top display
Bottom display
Limits
Sanitary SET
Temperature
Sanitary SET
Temperature
Summary of Contents for TERMO-VIOLA
