Initial Set-Up
Pre-Operation Equipment Inspection Checklist
Initial Set-Up
Lastec//021819
3-13
3
3.14 Pre-Operation Equipment Inspection Checklist
Perform the following equipment inspection prior to each operation of the Articulator.
With the tractor and Articulator parked on level ground, verify that the Articulator is properly
mounted to the tractor and secure.
Verify that the PTO shaft is properly mounted and secure, and the PTO shaft cover retaining
chains are secure.
Check the oil level in the gearbox.
Inspect area around and under the gearbox for any oil leakage.
Set the deck height to the desired level. If necessary, calibrate the deck height.
Check the deck drive belt and idler tension spring for proper installation, tension and condi-
tion.
Clean the entire center deck area (including under the belt cover) of all grease, oil, fuel,
grass, or debris. Be sure to replace all covers, shields, and guards.
Check all deck belts for proper tension.
Clean each entire deck area (including under the belt covers) of all grease, oil, fuel, grass, or
debris. Be sure to replace all covers, shields, and guards.
Inspect all blades for proper installation, orientation, tightness, sharpness, and overall condi-
tion.
Verify proper function of all wheels.
Verify that all warning decals are in place, visible and legible.
Verify that all covers and safety devices are properly installed and secure.
Check that the discharge chute is clear of debris, properly mounted, and in good condition.
Inspect entire Articulator for loose or entangled parts, debris, obstructions, or neglected
tools.
Perform all safety, set-up, and pre-operation procedures listed in your tractor manual.
Complete the appropriate maintenance checklist (section 5).
Summary of Contents for 100EFNH
