Initial Set-Up
Tires and Wheels
3
3-20
Lastec//020515
Initial Set-Up
3.18 Tires and Wheels
Check the air pressure in the rear drive tires. Maintain air pressure at 18 psi, or as needed
to maintain level deck cutting.
Check the air pressure in the front tires. Maintain air pressure at 12 psi, or as needed to
maintain level deck cutting
Verify proper function of all mower deck wheels. The wheels should turn freely without
excessive side-to-side motion, and be free of debris. Clean, adjust, replace, and grease
as necessary.
Check that each wheel swivels freely in the shaft pivot collar, and the bearings are in
good condition. If any wheel does not swivel freely, clean and grease the shaft collar
assembly. Replace the bearings if necessary.
3.19 General Inspection
Verify that all warning decals are in place, visible, and legible.
Verify that all covers and safety devices are properly installed and secure.
Check that the discharge chute is clear of debris, properly mounted, and in good condi-
tion.
Inspect entire Lastec Mower for loose or entangled parts, debris, obstructions, misplaced
tools, or any other possible safety hazards, equipment hazards, or projectile hazards.
Summary of Contents for 4520ZSR
