Operating Procedures
Starting The Engine
Operating Procedures
Lastec//020515
4-3
4
NOTE: The engine will not start without the parking break set.
The engine
will
start without an operator seated in the seat.
As with any diesel engine, you must first pre-heat the glow plugs under cold conditions
before attempting to start the engine. To do this:
1.
Turn the key switch counter-clockwise to the GLOW position for 9 seconds. After 9 sec-
onds, adequate preheat should take place.
2.
Turn the key switch clockwise to START position, cranking the engine for a maximum of
10 seconds.
NOTE: Cranking engine for more than 20 seconds will cause electrical failure!
3.
If the engine does not start within 10 seconds, discontinue cranking by turning the key
switch counter-clockwise to the OFF position. Wait 60 seconds. Repeat steps 1 through
3. If, after several attempts, the engine will still not start, discontinue the starting process
until the cause of malfunction is determined.
4.
When the engine starts, adjust the throttle lever (located on the right of the steering col-
umn) forward until the engine is running at a steady idle. Do not overpower the engine.
Throttle Lever
ZSR041-3
Summary of Contents for 4520ZSR
