Initial Set-Up
Operator Seat Pan
3
3-4
Lastec//020515
Initial Set-Up
3.4
Operator Seat Pan
Warning
WARNING!
Always clean the entire engine area and deck area of any excess grease, oil, fuel,
or debris to prevent damage to the equipment, fire hazard, and projectile hazards!
In order to fully access the mower deck, many of the drive components or controls, or the
engine area, you will need to open the operator seat pan:
Operator seat pan:
Lift the operator seat pan all the way forward, to its maximum open
position. If assistance is required when either lifting or lowering the operator seat pan,
have someone help you.
Clean the entire engine area and mower deck area (under the operator seat pan) of all
excess grease, oil, fuel, grass, or debris before operating your Lastec Mower. This will
help prevent damage to the equipment, fire hazard, and projectile hazards.
Be sure the operator seat pan is properly closed before operating or engine will not start.
3.5
Fuel Shut-Off Valve
The fuel shut-off valve is located on the right side behind the operator’s seat. Be sure the
fuel shut-off valve is in the ON position, indicating which tank to access, prior to attempt-
ing to start the engine.
LT0106
Summary of Contents for Articulator 2661AGC
