Initial Set-Up
General Inspection
3-21
8/23/22
Initial Set-Up
3
5.
Ensure each wheel swivels freely in the shaft pivot collar, and the bearings are in good
condition.
a.
Clean and grease the shaft collar assembly of any wheel that does not swivel
freely.
b.
Replace the bearings, if necessary.
3.20 General Inspection
Verify that all warning decals are in place, visible, and legible.
Verify that all covers and safety devices are properly installed and secure.
Ensure the discharge chute is clear of debris, properly mounted, and in good condition.
Inspect entire Lastec Mower for loose or entangled parts, debris, obstructions, misplaced
tools, or any other possible safety hazards, equipment hazards, or projectile hazards.
3.21 Engine
While the engine is running, check the exhaust. During proper operation, the exhaust
should be colorless. If the engine runs continuously with dark exhaust, stop the engine
and correct the problem before operating your Lastec Mower.
Listen for any unusual engine noises. If the engine suddenly slows down or accelerates,
makes any abnormal noises, runs roughly, or displays any other usual characteristics,
stop the engine and correct the problem before operating.
3.22 Hour Meter
The hour meter is located on the control panel. This meter records the total hours on the
engine, and cannot be reset. You may wish to record the hour meter reading prior to oper
-
ation for tracking of maintenance schedules, job timing, billing, or other records.
3.23 Maintenance Checklists
Complete the appropriate maintenance checklists in a timely manner. (See section 5).
