Operating Procedures
Stopping The Engine
4-5
8/23/22
Operating Procedures
4
2.
Release immediately when the engine starts.
NOTE:
The key switch returns to the RUN
position.
3.
Adjust engine speed with the throttle switch on the control panel (or by using the up/down
arrows on the engine controller).
a.
Press and hold for large speed adjustments;
b.
Press without holding for incremental adjustments.
NOTE:
Do not overpower the engine.
4.3 Stopping The Engine
1.
Stop the engine by throttling down to a slow idle.
2.
Turn the ignition key switch to the OFF (STOP) position.
3.
Wait for all motion to stop.
4.
Set the PTO switch in the OFF position.
5.
Set the parking brake before dismounting your Lastec Mower.
4.4 Engine Controller
Menus
The operator menu contains information about the engine and control panel.
NOTE:
Once you have accessed the menu system, the four key pad
buttons will be used for menu navigation and therefore not available for
engine speed control if the engine is running.
