Initial Set-Up
Engine
Initial Set-Up
8/18/20
3-20
3
Ensure the discharge chute is clear of debris, properly mounted, and in good condition.
Inspect entire Lastec Mower for loose or entangled parts, debris, obstructions, misplaced
tools, or any other possible safety hazards, equipment hazards, or projectile hazards.
3.20 Engine
While the engine is running, check the exhaust. During proper operation, the exhaust
should be colorless. If the engine runs continuously with dark exhaust, stop the engine
and correct the problem before operating your Lastec Mower.
Listen for any unusual engine noises. If the engine suddenly slows down or accelerates,
makes any abnormal noises, runs roughly, or displays any other usual characteristics,
stop the engine and correct the problem before operating.
3.21 Hour Meter
The hour meter is located on the control panel. This meter records the total hours on the
engine, and cannot be reset. You may wish to record the hour meter reading prior to oper-
ation for tracking of maintenance schedules, job timing, billing, or other records.
3.22 Maintenance Checklists
Complete the appropriate maintenance checklists in a timely manner. (See section 5).
3.23 Pre-Operation Equipment Inspection Checklist
Perform the following equipment inspection
prior to each operation
of the Lastec
Mower:
Verify that the parking brake is set.
Check the fuel level.
Check engine oil level and condition.
Check the air cleaner and filter elements for contamination or debris.
Brush out and clean the radiator screen.
Clean entire mower deck area under operator seat pan of any grease, oil, fuel, grass, or debris.
Check coolant level and condition in overflow tank.
Check hydraulic fluid level and condition.
Add if low - do not overfill.
Change oil and filter if necessary.
Inspect the entire hydraulic system for leaks.
Adjust hydrostatic pumps if needed.
Check both hydrostatic pump belts and tension springs for proper installation and condition.
