Initial Set-Up
Wheel yoke height of cut adjustment
3
3-10
WZ1000 6/5/23
Initial Set-Up
Wheel yoke height of cut adjustment
CAUTION!
Raise the deck to transport before adjusting wheels. Do not adjust the height of cut with the decks in the
lowered positions.
There are a total of (6) ½" spacers and (2) ¼" spacers. With no spacers on the bottom area, the deck will be set at 1" height of
cut.
1.
Remove the top retaining pin.
2.
Remove the top washer.
3.
Allow the caster assembly to slide down approximately 1/2 inch.
4.
Reposition spacers as needed.
a.
Spacers below the yoke mount are added or removed by aligning the spacers with the flat area at the bottom of
the shaft.
b.
Spacers above the yoke mount are added or removed by slipping them over the top of the shaft.
5.
Replace the top washer.
6.
Replace the retaining pin.
TDWZ1-15
Retaining pin
Top washer
Slide down
1/2 inch
Flat area
