Operating Procedures
Motion Control
4
Operating Procedures
WZ1000 6/5/23
4-9
At the end of the process, the controller will prompt the operator that the regeneration has been completed. The operator must
acknowledge this by pressing the Enter button prior to resuming normal operation and loading the engine.
REGEN FAIL / ABORT
The regen process will be aborted if either the Neutral Switch or the Parking Brake circuits open during the process. When this
occurs, a message will appear requiring the operator’s acknowledgement.
The condition causing the abort will need to be rectified and the regen process reinstated from the beginning.
If a regen fails or aborts, the controller will post a message such as Regen Failed or Regen Aborted. Each screens will require
the operator’s acknowledgment. When these circumstances occur, the operator should contact a dealer for instructions.
4.5 Motion Control
WARNING!
Clear the entire area of all non-essential personnel before operating your Lastec Mower.
Verify that all safety covers are in place and secure before operating your Lastec Mower.
Wear the seat belt, ear, and eye protection during operation.
Your Lastec Mower is equipped with a dedicated hydrostatic pumps for each rear drive wheel. These pumps are controlled sep
-
arately with each of the steering control levers (located to the left and right of the operator seat).
Pushing a steering control lever forward activates the hydrostatic pump on the corresponding side, turning the drive wheel in
the corresponding direction.
The steering control levers also govern the ground speed of your Lastec Mower. The farther from the neutral position the lever
is pushed or pulled, the faster the corresponding drive wheel turns.
Ground speed
WARNING!
Maximum ground speed is intended for transport to and from the work site only, and should not be
attempted during any cutting operation.
Reduced ground speed is required when operating on severe contours, when cutting excessively tall, wet, or thick
grass, or when traveling up or down large or steep hills.
Changing direction at high ground speed, whether cutting or transporting, can cause damage to the turf, especially in wet con
-
ditions. Direction changes should be made by slowing to a near or complete stop (returning the control levers to neutral posi
-
tion), and slowly changing the control levers positions to begin travel in the desired direction. This prevents turf damage, as well
as prolonging equipment life and promoting safer operation of your Lastec Mower.
