Key Phrase Detection on HM01B0 UPduino Shield Demonstration
User Guide
© 2019 Lattice Semiconductor Corp. All Lattice trademarks, registered trademarks, patents, and disclaimers are as listed at
All other brand or product names are trademarks or registered trademarks of their respective holders. The specifications and information herein are subject to change without notice.
8
FPGA-UG-02094-1.0
Figure 4.4. Radiant Programmer – iCE40 UltraPlus Device Selection
8.
Click the iCE40 UltraPlus row and select Edit > Device Properties.
9.
In the Device Properties dialog box, apply the settings below that are common to the three files to program.
a.
Under Device Operation, select the options below:
Target Memory: External SPI Flash Memory
Port Interface: SPI
Access Mode: Direct Programming
Operation: Erase, Program, Verify
b.
Under SPI Flash Options, select the options below:
Family: SPI Serial Flash
Vendor: Winbond
Device: W25Q32
Package: 8-pin SOIC
10.
To program the bitstream file, select the options below as shown in
a.
Under Programming Options, select the key phrase RTL bitstream file in Programming file.
b.
Click Load from File to update the Data file size (Bytes) value.
c.
Ensure that the following addresses are correct:
Start Address (Hex): 0x00000000
End Address (Hex): 0x00010000
d.
Click OK.
Summary of Contents for HM01B0 UPduino Shield
Page 15: ...www latticesemi com ...
