Aqualine
15.03.18/ YACE0086
Starting up
17
7 Operation
7.1 Mains connection
Compare the rating on the name-plate with the mains voltage.
Connect the unit only to sockets with a protective earth conductor (PE).
No liability is accepted for incorrect mains connections!
Please make sure that your mains plug is equipped with at least the following safety
fuses see (
10 Technical Data).
Ensure that the unit is filled in accordance with Section 6.2!
Note for electric installation on site:
The devices must be protected with a 16-ampere circuit breaker fitted during installation.
Exception: Devices with 13 ampere UK plugs.
7.2 Switching on
Switch on using the mains switch. The green LED indica-
tor is illuminated.
The controller runs a self-test after switching on. For a few
seconds all segments are flashing.
First the current bath temperature is displayed.
The values are accepted which were set before the
switch-off.
If an alarm has occurred, the LED 1 is illuminated.
If the heater feeds heat to the bath, at the normal operation, the LED 2 is illuminated.
2§1
°
C
!
fnc
set
LED 2
LED 1
Summary of Contents for AL 2
