ECOLINE Staredition
27.06.2018
3
Peculiarities of the types RE 212 J, RE 312 J:
1
Description
The thermostats are especially equipped to calibrate glass thermometers or electric thermometers. The
cylindrical (working) chamber can be adjusted in its height up to 20 mm approximately and therefore it is
possible to adjust the surface of the liquid bath within the working chamber higher than the (bath) cover.
Therefore, the total immersing thermometers can be read right at the point of immersion. Additionally the
separate working chamber provides a constant immersion depth, independent from the volume
extension of the bath liquid, an extremely good temperature accuracy and distribution of temperature.
There are pump connectors to connect other external closed circuits, but won’t be available if the
thermostat is used for calibrating.
Side view
Top view
EU conformity
The device complies with the basic health and safety requirements outline in the
Directives listed below.
Machinery Directive 2006/42/EC
EMC Directive 2014/30/EU
LAUDA DR. R. WOBSER GMBH & CO. KG
– Pfarrstraße 41/43 –
97922 Lauda-Königshofen
– Germany
The device does not fall under Pressure Equipment Directive
2014/68/EU because the device is only classified as high as Category 1
and is covered by the Machinery Directive.
Connection tube
LZM 045
Screw for adjustment (3x)
Summary of Contents for RE 212 J
Page 2: ......
