56
LAUNCH
X-431 PAD V
User's Manual
3
Good-recharge Stands for low battery. The battery is good
itself.
4
Charge-retest
It is better for a few batteries to be fully
charged before testing in order to avoid
judging in error under special conditions.
5
Bad cell
Indicates one of the battery cells is bad and
can not work normally, but for which one is
bad, it can’t be verified. In this case, battery
voltage is generally lower than 11V, mainly
resulting from internal circuitry damage, such
as short circuit, open circuit, dummy weld
etc.
7.2.3 Batterybox Structure and Test Accessories
7.2.3.1 Batterybox structure
1
2
3
4
Fig.7-11 Batterybox structure diagram
Below describes the ports and indicators for the Batterybox.
No.
Name
Descriptions
1
Power LED
It keeps solid red after the Scopebox is
powered on.
2
B-shaped data
I/O port
Connect to the diagnostic tool via data
cable so that the signal can be displayed
on the tool.
3
Battery
connector
Connect the Kelvin clip to battery for
battery test.
4
Status LED
7.2.3.2 Test accessories
Fig. 7-12 Kelvin clip
Fig. 7-13 Data cable
7.2.4 Connections & Operations
7.2.4.1 Connection
Connect one end of the data cable to the B-shaped data I/O port of the
Batterybox, and tighten the captive screws, and then connect the other
