LAUNCH KWA-300 3D Wheel Aligner Introduction
1-4
automatically test the aligning angles with high
performance camera.
z
Positive targets: there are no electronic
components inside the targets, and no cables
between the targets and the main unit, so the
targets are easy to be fastened on the wheel
clamps.
z
Provides many kinds of auto test processes and
diagram operating interfaces, very simple and
clear to operate; the whole test process can be
performed automatically, and there are some
humanity tips on the corresponding interfaces.
z
Complete databank: wheel alignment data of over
20,000 vehicle models is stored in the system.
User can also add new data to the databank.
z
Automatically record the history data, easy for
customer measurement.
z
Profuse vehicle adjustment animation and HELP
information.
z
Provide real-time help with help system.
z
Provide the function of data back-up and
restoration, and of software upgrade.
Specification
Item Resolution
Test
Range
Total toe-in
2
′
0~
±
20
º
Camber 2
′
0~
±
20
º
Caster 4
′
0~
±
25
º
Steering axle inclination
4
′
0~
±
25
º
Maximal rim size
Depending on the size of the
wheel clamp
Notes:
1.
The right of changing the design will be reserved by manufacturer;
2.
The above accuracy can be confirmed only when the user follows the specified operation procedures.
Requirements on Surroundings
Item Specification
Ambient temperature
0~+50
℃
Relative humidity
≤
85%
Light requirement
No direct strong lights irradiate the target and reflect to the camera
The height difference between the left rail and
right rail of lift
<1mm (left to right); <2mm (front to back)
Working Principle
The working framework of KWA-300 3D Wheel Aligner is as shown in Fig.1.9. The whole system is composed of data
collecting system and data processing system.
Summary of Contents for KWA-300
Page 1: ......
