LAUNCH KWA-300 3D Wheel Aligner Operation Instructions
4-6
[Figure format]: Figure format data display mode is
newly added in the system. Click [System Setting] and
select [Switch between Letter Format and Figure
Format]. The interface is as shown in Fig.4.18.
Fig.4.18
Caution:
1.
Before perform kingpin measurement, please
install brake pedal depressor and lock the
hand brake first, in order to ensure the
vehicle wheels cannot move; remove the
steering wheel holder finally.
2.
The measured values are displayed with
different colors on each measurement
interface.
z
Green, it indicates that the measured
values are within the standard
specifications.
z
Red, it indicates that the measured
values are beyond the standard
specifications.
z
Blue, it indicates that this measured
parameter has not the standard
specification.
Rear axle measurement
This interface can provide the real-time result related to
rear axle measurement, the operator can compare the
measurement result with the reference data while
adjusting the vehicle, until the vehicle is adjusted to the
best status. The interface is as shown in Fig.4.19.
Fig.4.19
[Double click]: Double click (with left key of the mouse)
on the data display forms for camber and toe-in of RL
and RR wheels, the corresponding displayed data will
be enlarged. The interface is as shown in Fig.4.20.
Fig.4.20
[Additional Measurement]: This interface provides an
operating platform for special measurement, which can
measure and display left lateral offset, right lateral offset,
axle offset, front setback, rear setback, track width
difference and wheelbase difference, etc. The interface
is as shown in Fig.4.21.
Fig.4.21
Double click
Put up the vehicle body
Summary of Contents for KWA-300
Page 1: ......
