Launch KWA-300, User Manual

LAUNCH                             KWA-300 3D Wheel Aligner                Operation Instructions

4-9 

Fig.4.29 

5.

Put down the vehicle to position B1. Adjust the 
vehicle front toe-in to the allowed scope according 

to the standard specifications. The interface is as 
shown in Fig.4.30: 

Fig.4.30 

6.

Put down the vehicle, and then click 

button to return to the interface of [Front Axle 
Measurement].  

Attention: After adjustment, please remember to click 

 button, and then put down the vehicle body 

according to the prompts on the screen. If the lift is not 
put down, it will be limited to select the other interfaces 
(except for [Rear axle measurement] interface) as 
shown in Fig.4.31. 

Fig.4.31 

Print Report 

Print Report can print and save the alignment data of the 
vehicle under test. The interface is as shown in Fig.4.32. 

Fig.4.32 

[Vehicle license plate number]: The license plate number 
of the vehicle under test. 

[Client information]: The corresponding information for 

the owner of the vehicle under test, including [Client 
name], [Contact], [Telephone] and [Address]. The client 
information cannot be directly entered in this interface 
with the keyboard. Icon 

behind [Client name] must 

be clicked to enter the interface of [Client Management], 
and then the corresponding [Client information] can be 
selected. If information of this client is not available in 
[Client Management], it must be added first before 

selection (Please refer to [Configuration] – [Client 
management]). 

[Vehicle information]: The corresponding information of 
the vehicle under test, including [Mileage], 

[Manufacturer], [Model], [Start year] and [End year]. The 
vehicle information cannot be directly entered in this 
interface with the keyboard. If the vehicle model has 
been selected in [Measurement] – [Select vehicle model], 
the corresponding information of the vehicle model 
selected will be displayed in this interface. If not, no any 

information is displayed in this interface. 
 
[Operator]:    Name of the operator who is operating the 
instrument now. The corresponding [Operator] can be 
selected only after the [Operator] column of [Information 

for service station] is added (Please refer to [System 
management] – [User information]). 
 
[Fault cause]: The symptoms of the vehicle under test. 
There are 5 options: [Tire wear], [Pull], [Steering wheel 

is not centered], [Steering wheel swings] and [Others]. 
 
[Save]: To save the alignment data of the vehicle under 
test ([Vehicle plate number] and [Client name] must be 
entered, and [Fault cause] must be selected first before 

Print 

Save 

Vehicle license plate 
number 

Client information 

Fault cause