Launch KWA-300, User Manual

LAUNCH                             KWA-300 3D Wheel Aligner                Operation Instructions

4-10 

saving). 

 
[Print]: To print the alignment data of the vehicle under 
test in the format of form or image (Please refer to 
[System management] – [Report setting] for the format 
setting of the report form). 

 
Caution: The report form print function provided by this 
interface only aims at the individual information report 
form for the test at this time; the report form print 
function provided by the main interface aims at all the 
information report forms saved and done before. 

Quick Measurement 

Select [Quick measurement] icon on the main menu, the 

system will enter the [Quick measurement] interface. 
This interface provides an operating platform for quick 
measurement, which can test and display toe-in and 
camber of front and rear wheels at the same time. The 
interface is as shown in the following figure: 

Fig.4.33 

[Select Vehicle Model]: You can select the parameters of 

standard vehicle models to be convenient for vehicle 
adjustment (Please refer to [Standard 
Measurement]-[Select Vehicle Model]); 
[Print Report]: To provide the functions for saving and 
printing the test data (Please refer to [Standard 

Measurement]-[Print Report]). 
[Figure Format]: It is the data display interface which can 
be switched to Figure Format. The fig-format data 
display interface provides the display for thrust angle. 
The interface is as shown in Fig.4.34. 

Fig.4.34 

Note: 
1.

This interface provides only the functions of the 

test and adjustment for front and rear toe-in and 
camber. For other functions, please select them 
on the interface of [Standard Measurement]. 

2.

The default unit for toe-in on this interface is 
centigrade. Only the vehicle model data is 

selected, can the display unit for toe-in be in 
accordance with the toe-in unit set on the 
interface of System Management]-[System 
Setting]. 

3.

Only the vehicle model data is selected, can the 

measured values be saved in the interface of 
[Print Report]. 

Additional Measurement 

This interface provides an operating platform for special 
measurement, which can measure and display left 
lateral offset, right lateral offset, axle offset, front setback, 
rear setback, track width difference and wheelbase 
difference, etc. The interface is as shown in Fig.4.35. 

Fig.4.35 

[Select Vehicle Model]: Click this button to select the 
parameters of standard vehicle model. If the parameter 

values of wheelbase and front/rear track width are 
contained in the standard database, each angle value 
displayed on the screen will automatically be converted 
into length value with the unit of mm. 
 
[Chassis measurement]: Click this button

，

the interface 

Select Vehicle Model 

Image format 

Print report 

Select Vehicle Model 

Chassis measurement