LAUNCH KWA-300 3D Wheel Aligner Operation Instructions
4-11
is as shown in Fig.4.36.
Fig.4.36
Enter the actual width values of front and rear rims
according to the requirement, and then click [OK] button
to enter the interface as shown in Fig.4.37.
Fig.4.37
Caution:
The system provides the dynamic measurement and
display for these special values, but the
measurement result will not be saved in the
database.
System Management
On the main menu, please click the icon of [System
Measurement] to enter the measurement interface as
shown in Fig.4.38.
Fig.4.38
User information
[]
The information of maintenance station is mainly used to
record the contact method of the maintenance station
and the information of the maintenance technician. This
kind of information can be imported to report forms,
which can make the information of maintenance station
be displayed on the report form printed out, and is
convenient for your data management and tracing
operation. The interface is as shown in Fig.4.39.
Fig.4.39
[Setting]: After entering this interface, the information
box will be displayed with French gray back-ground, in
this state the system only provides view function.
Click
button to perform information editing
operation.
After entering the information, please click
button,
the system will automatically save the information and
return to the previous interface.
Note: If there are multi-operators for performing
wheel alignment, the input method of recording or
saving the operators' names is using "#" to separate
every operator's name. For instance,
Tom#John#Paul#Steven#.
Client management
Client information is very important in our daily routine,
so we must manage and maintain these data very well,
which can ensure us to solve the problem in time and
improve our service quality. The interface is as shown in
Fig.4.40.
Summary of Contents for KWA-300
Page 1: ......
