LAUNCH KWA-300 3D Wheel Aligner Operation Instructions
4-16
Fig.4.56
Click [NEXT] icon to calibrate the next target. Click [OK]
icon after finishing the whole calibration process.
Note:
Perform the calibrating operation during equipment
installation. Generally speaking, only in following
two cases is the calibrating operation performed:
1.
The camera is adjusted or moved;
2.
The target is changed.
Please do not perform the calibrating operation in
normal test operation.
In main interface, click the icon of [Print] to enter the
interface of repot form print. It is mainly used to check or
print the normal testing records of the client. The
interface is as shown in Fig.4.57.
Fig.4.57
[Client list]: To list the all clients who have been serviced
by the alignment test.
[Record list]: This list can display the alignment test
records (for one time or many times) of the client
selected from [Client list].
[Print]: To print the alignment data of the vehicle under
test with form or figure format (Please refer to [System
Management] – [Report Setting] for the format setting of
report form).
Help
User can press F1 key or click [HELP] button to enter
the help system on any interface. The help subject
depends on the content of the current screen. User can
also select [Content] or [Index] to enter the help subject
after entering the help system, see Fig.4.58.
Fig.4.58
The help system includes the following information:
z
Operation of wheel aligner software
z
Basic knowledge on 4-wheel alignment
Exit
EXIT system has two kinds of prompts: Exit from the
system and return to WINDOWS operating interface or
Exit and shutdown (Please refer to [System
Management] – [System Setting] for the detailed
settings). The interface is as shown in Fig.4.59.
Fig.4.59
Client list
Record list
Summary of Contents for KWA-300
Page 1: ......
