LAUNCH
Installation Instruction for Economical Symmetric Floor-plate 2-post Lift
3
2
700
186
986
30
0
30
0
2586
3370
12
00
R8
00
Figure 2
2.2 Main structure and principle
of the equipment
z
Lifting mechanism: Each of the two columns has
one hydraulic cylinder respectively. When the
power unit works, the hydraulic oil gets into the
lower chamber of the cylinder, forcing the piston
rod moves upward. At this time, the carriage
moves upward through the chain.
z
Supporting mechanism: When the vehicle enters
into the working area, adjust the position of two-
stage telescopic swing arms to make the lifting
pad near the correct lifting point of the vehicle,
and then adjust the screw height below the pad
to adapt to different heights of vehicle chassis.
z
Balancing mechanism: To keep the balance
during the lifting and lowering process, the lift
uses two steel cables to interconnect two
carriages, forcing the carriages to rise and
descend synchronously. If the carriages and
swing arms are not on the same level, adjust the
screw at the end of the steel cable, making the
swing arms at the same level (equal position
from the floor). At this time, the steel cables
must be adjusted tightly with equal tension,
otherwise the equalization can’t be ensured.
z
Manual safety locking system: the safety locking
plates are installed on the two carriages and the
toothed bar plate is welded on the internal wall
of the column. During the lifting of the carriage,
Passing width 2486
