LAUNCH
TLT830WA Product Manual
12
16 M16x160mm(M0.63
″
x6.3
″
) anchor bolts
（
Fig.11
）
z
Rotate adjustment screws on the base plate; adjust the plat until they are leveled.
And the host and auxiliary table height difference is not greater than 3mm(0.1
″
)
。
Choose the right thickness
of steel plate as a gasket (accessories) put it under the base plate; gasket should be inserted with both sides
of expansion bolts.
z
Tighten out the nuts to fix the base frames on the pits.
z
If installed on the ground, then follow the steps above to install anchor bolts of the approach plate.
M16x160mm(M0.63"x6.3")
φ22
150
drilling
clean
expanding
fastening
Fig 10
Cautions:
z
To ensure safety and performance, follow the installation procedures step by step.
z
Wear safety goggles
。
z
Use strong alloy drill bit with a diameter of 17mm
（
0.7
″
）
. Do not use worn-out drill bit
z
Keep the hammer drill upright with the surface of the hole.
z
Keep hammer drill going by itself. Do not apply extra pressure.
z
The depth of the hole depends on the length of the bolt. It is advisable that the bolts above the base
frames should be around 30mm.
（
1.2
″）
z
Remove the dust from the holes.
z
Tap the bolt into the hole, insert and hit the core until the bolt fully expands
z
Tighten out the bolts with torque wrench with a capacity of 80N.M
5.2.6 Air Hose Connection
z
Connect the hoses according to the pneumatic diagram
z
Keep the output pressure of the air source at 5kg/cm2.
z
Press down button to check if the air cylinder acts correctly. If not, please check the hose connection.
