LAUNCH
X-431 PAD III User Manual
26
Fig. 4-13
B. Battery Clamps Cable: Connect one end of the battery clamps cable to
vehicle’s battery, and the other end to the power jack of OBD I adaptor.
Fig. 4-14
4.3.3 Vehicle connection (For Commercial Vehicle/ Gasoline & Diesel
Version)
The method used to connect the VCI module to a vehicle’s DLC depends on the
vehicle’s configuration as follows:
A. OBD II Vehicle Connection: Plug one end of the diagnostic cable into the
vehicle’s DLC, and the other end into the diagnostic socket of the VCI module,
and then tighten the captive screws.
Fig. 4-12
B. Non-OBD II Vehicle Connection: For vehicles with non-OBD II diagnostic
socket, a non-16pin connector (adaptor cable) is required.
Fig. 4-13
