LAUNCH X-631/X-631+ Wheel Aligner Operation Instructions
4-9
Fig.4.26
Operating Methods:
1.
Click [Toe-in Curve Change] on the interface of
[Front Axle Measurement] to enter Toe-in Curve
Change interface as shown in Fig.4.24.
2.
According to the prompts on the screen, please
select the appropriate vehicle adjustment tools by
the way of referring to the vehicle adjustment
HELP information for the front toe-in curve change
regulator. Please perform the next operation
procedure after finished.
3.
The vehicle is now in put-down status (position B1).
Adjust the vehicle front toe-in to the allowed scope
according to the standard specifications (see
Fig.4.25). Put up the vehicle with the special tools
equipped according to the prompts on the screen.
Click [NEXT] button, the screen will display the
interface as shown in Fig.4.27.
Fig.4.27
4.
Put up the vehicle (to position B2) according to the
requirements of the manufacturer. The screen
display the interface as shown in Fig.4.28:
Fig.4.28
5.
Put down the vehicle to position B1. Adjust the
vehicle front toe-in to the allowed scope according
to the standard specifications. The interface is as
shown in Fig.4.29:
Fig.4.29
6.
Put down the vehicle, and then click
button to return to the interface of [Front Axle
Measurement].
Attention: After adjustment, please remember to click
button, and then put down the vehicle body
according to the prompts on the screen. If the lift is not
put down, it will be limited to select the other interfaces
(except for [Rear axle measurement] interface) as
shown in Fig.4.30.
Fig.4.30
Print Report
Print Report can print and save the alignment data of
the vehicle under test. The interface is as shown in
Fig.4.31.
Summary of Contents for X-631 Plus
Page 1: ......