LAUNCH X-631/X-631+ Wheel Aligner Maintenance
5-1
Maintenance
To prolong the life of the equipment, users should
maintain it with care. The Wheel Aligner is precision
equipment. Here we will tell you the general
knowledge about equipment maintenance.
Computer
z
User should have a basic knowledge about
computer software and hardware to insure the
normal operation of the computer.
z
The main unit and the monitor should be firmly
placed on the desk. Do not put them in a
freezing, wet, extremely hot place or expose
them to direct sunlight, or near the source of
radiation and heat.
z
Don’t foist anything into the main unit and the
monitor through the gap.
z
Don’t move the computer during operation.
z
Do not switch on/off the computer too frequently.
z
Don’t change the BIOS setting at will.
z
Don’t delete the unknown files in the hard disc at
will to avoid abnormal computer operation or
dead.
z
The computer is wholly used for the Wheel
Aligner; don’t install other software to the Wheel
Aligner computer to avoid computer virus. The
computer is checked to ensure it is free of virus
before leaving factory.
z
Don’t use other software to avoid possible virus.
LAUNCH warranty does not cover the system
problem arising from the virus.
z
After a long period of use, the dust and oil dirt
will be accumulated on the main unit and the
monitor. Please cleanout it with neutral
detergent or dehydrated alcohol. Avoid using oil
or caustic product.
z
Never disassemble the computer and move the
inside cables and cards to avoid damage of the
inside components.
Wheel Clamp and Probe Rod
z
The wheel clamp should be cleaned and
lubricated timely to insure that the span of claws
can be easily adjusted and the probe rod can be
attached easily.
z
The housing of the sensor probe rod is made up
of Aluminum and plastic, after a long period of
use, the dust and oil dirt will be accumulated on
the surface, please cleanout it with neutral
detergent or dehydrated alcohol. Avoid using oil
or caustic product.
z
The sensor probe rod is a precision component;
please take care while using it. Tampering with it
may cause damage of the internal units and thus
affect its normal operation.
z
Ensure that the clamp have been firmly secured
before installing the probe rod and connecting
the power connector. After finishing test,
disconnect the power first.
z
Don’t disassemble the sensor probe rod to avoid
damage of its elements. LAUNCH will not
guarantee for this kind of failure.
Printer
z
Read the operation instruction of the printer
carefully.
z
Install suitable printer drive program, and apply
right printer setting.
z
If the printed words are not clear, it may be that
the ink is used out. Please replace the printer ink
cartridge in time to resume the printing quality.
z
For other printer related problems, please
contact the LAUNCH Customer Service Center.
Summary of Contents for X-631 Plus
Page 1: ......
