+1.800.867.4580 sales@laundryjet.com www.laundryjet.com
9
Pipe Installation Standards
4.1
Pipe Installation Overview
Pipe Installation Standards
Required Piping Installation Standards
▪
All joints must use a minimum entry angle of 45 degrees with a break distance of 18 Inches
(460 MM). See Image below.
▪
Pipe cuts must be straight and de burred before seating.
▪
Pipe must be completely seated in fitting connections.
▪
Seal all joints using standard PVC glue.
Connections must be glued around 360 degrees
to ensure maximum system performance.
▪
System must be strapped with “plumbers tape”
(or equivalent) every 6 feet. Port 90 must be
strapped and secured prior to Port installation.
▪
Install Cleanout ports every 50 feet on angled runs. Straight trunk lines can run up to 100
feet with cleanouts at either end.
