Filling
Please refer to the last two pages of the manual.
Unscrew the appropriate cap
(17)
and fill the boiler with water. To fill
it up use the bottle
(10)
provided: it has an anti-overfill device which
stops the flow when the boiler is full (the capacity of the bottle is
greater than that of the boiler).
Squeeze the bottle briefly to start the filling of the boiler. Once full,
screw the filling cap back on again
(17)
as far as it will go.
3
English
Fix the board in the highest
position. Put the rinsing recep-
tacle beneath the boiler.
Unscrew the drain cap
(16)
.
Unscrew the filling cap
(17)
.
Pass the contents of a bottle
(10)
of hot water through the
boiler to rinse it. Screw the
drain cap back on again
(16)
.
Screw the filling cap back on
again
(17)
.
CAUTION: Fill up the boiler
before every use.
Première utilisation
Using for the first time
System disconnected
Rinsing the boiler
Always unplug the mains before
filling the boiler.
What sort of water to choose?
Getting started
Always fill the boiler with water before starting to iron as it could be damaged if heated up while empty.
CAUTION:
Heating up without water invalidates your system’s guarantee.
Filling before using the system
Water hardness test included.
MagicEVO2-PreEVO2 Anglais 28.1.2003 10:16 Page 5
