OPTIONAL: HYDROMASSAGE BUBBLE SYSTEM
Functioning:
1) 16 lateral turbo air jets spaced around the lower side wall of the tub.
2) This system functions with a 2 HP heated blower independent of any other system.
3) This system requires a 20 AMP dedicated circuit, 120 Volt.
Controls:
1) The hydro bubble system operates with the touch of the control pad, which is oblong and about 4 inches long.
2) On the control pad there are four functions: 1-ON/OFF, 2-PLUS (speeds up the blower speed), 3-MINUS (slows the speed of the blower),
4-VARIABLE (automatically speeds up and then slows down the blower speed).
3) There is a purge cycle that automatically comes on 20 minutes after the blower is shut off. This purge cycle blows air to dry any water
from the air nozzles of the hydro bubble system and runs for approx. 30 seconds. Do not interupt the purge cycle, because it will reset to
another purge cycle.
OPTIONAL: NECK MESSAGE PILLOW
Control Features:
• Pump ON/OFF with water sensor control
• Pillow control ON/OFF
• Pillow control speed buttons (3 speeds)
• Automatic 30-minute run-timer for pump
Single Speed Pump Motor Operation:
Once the system run-timer has been programmed, the pump is available for activation. Press button 1 to turn the pump ON
and press button 1 again to turn pump OFF.
Pillow Operation Using the Speed Up/Down Keys:
The pump must first be active in order to have control of the pillow operations. A press and release of the pillow button
turns the pillows full ON and full OFF. Once the pillows are operating a press and hold of the pillow button for 2-seconds
will illuminate the speed Up/Down button LEDS. Once the LEDS are illuminated, the speed buttons can be pressed to select
from the 3 pillow speeds. The button LEDS will remain on for ten seconds of absent button pressing.
The Automatic 30-Minute Run-Timer:
Once the system motor has been activated, an automatic timer is set to 30-minutes. The system will stay in operation until
the run-timer expires, at which time all functions will shut down. The light device timer runs independent of the main
system run-timer.
OPTIONAL: CHROMATHERAPY MOOD LIGHT
Choosing Lighting Modes
The ColorGlo
TM
LED Multi-Color Bath Light comes pre-programmed with 5 exiting lighting modes.
To advance to the next lighting mode, switch the unit off and then on again within five seconds.
To resume a lighting mode, leave the unit switched off to store the last lighting mode displayed in memory.
That same lighting mode will display the next time the unit is switched on.
•
•
Safty Precautions
Be sure to follow all instructions in this user guide and carefully observe all safety precautions.
Do not attempt to service the electronic components yourself. Non-expert handling may cause injury to the user and/or damage the unit. Any
opening, altering or tampering with this product will void the manufacturer’s warranty.
Do not submerge this unit in water or allow it to get wet. Keep the unit dry at all times.
Do not allow this unit to freeze.
Always handle this unit cautiously, being careful to never drop it.
•
•
•
•
RISK OF ELECTRICAL SHOCK OR
ELECTROCUTION
Always disconnect power to the bath light
at the circut breaker before servicing the
light. Failure to do so could result in death
or serious injury to the installer, bath
users, or others due to electrical shock.
DANGER
LAUREL MOUNTAIN WHIRLPOOL, INC.
7
Summary of Contents for Colony Series
Page 1: ... E157308 ...
