INSTALLATION & OWNER’S MANUAL
8
LAUREL MOUNTAIN
WHIRLPOOL, INC.
LIMITED WARRANTY
This Laurel Mountain Whirlpool, Inc. bath is
warranted to the original consumer purchaser
to be free from defects in material and work-
manship for the following period:
The bathtub is warranted for a period of five(10)
years.
The plumbing system (including pump) is war-
ranted for a period of three(5) years.
This warranty is made to the original consumer
purchaser and shall be effective from the date
of purchase as shown on purchaser’s receipt.
Laurel Mountain Whirlpool, Inc. will repair or
replace (at its option) any unit which proves to
be defective in material or workmanship un-
der normal use and service, having been prop-
erly installed. THIS WARRANTY IS THE ONLY
EXPRESS WARRANTY MADE BY LAUREL
MOUNTAIN WHIRLPOOL, INC. AND IS LIM-
ITED TO THE DURATION OF THIS WARRANTY.
LABOR CHARGES AND/OR DAMAGE IN-
CURRED IN INSTALLATION, REPAIR OR RE-
PLACEMENT AS WELL AS INCIDENTAL AND
CONSEQUENTIAL DAMAGES CONNECTED
THEREWITH ARE EXCLUDED AND WILL NOT
BE PAID BY LAUREL MOUNTAIN WHIRLPOOL,
INC.
Some states do not allow the exclusion or limi-
tation of incidental or consequential damages,
so the above limitation or exclusion may not
apply to you.
This warranty is void for any damage to the
whirlpool bath due to abuse, misuse, neglect,
accident, improper installation, any use viola-
tive of instructions furnished by us, or modi-
fication or repair not authorized in writing by
Laurel Mountain Whirlpool, Inc.
TROUBLE SHOOTING–PROBLEM, CAUSE, SOLUTION CHART
PROBLEM
CAUSE
SOLUTION
AIR SWITCH BUTTON
Won’t depress/sticks
Pump
Altering of pump location
VOIDS warranty
Leaks
• Debris in body of button.
• Won’t start.
• Motor hums.
• Not priming.
• Pump o-Ring or seal.
• Pump Unions.
• Pipe to Jet.
Remove trim ring and plunger.
Clean interior, lubricate with small amount
Of vasoline or marine grease.
Check to see if on/off switch or
pneumatic switch is ON.
Check circuit breaker.
Check wiring.
Check to see if both ends of Plastic air
switch tube are Connected.
Check for binding of motor shaft or
obstruction in pump. Manually rotate
motor shaft to see that shaft turns freely.
Check to see if highest jet is clogged.
Check to see that water is at a high
enough level for pump to prime.
Check for air leak in suction line - slightly
loosen pump union and then retighten
by hand.
Check for obstruction in piping system.
Call dealer.
Loosen pump unions and inspect
O-ring for proper sealing. Retighten.
Call dealer for repair.
Summary of Contents for Colony Series
Page 1: ... E157308 ...
