LAUREL MOUNTAIN WHIRLPOOLS
Owner’s Manual
Page 9
CARE AND CLEANING
Your tub has an acrylic finish and will retain its high luster for years with proper car.
Never use an abrasive cleaner or pad to clean your whirlpool. Always use a soft cloth or
sponge along with a spray liquid non-abrasive bath cleaner/disinfectant. On the metal trim,
use only a soft cloth and warm soapy water. Rinse and dry as with any highly polished metal
fixture.
WHIRLPOOL CLEANING INSTRUCTIONS
Before using the whirlpool bath, the system should be thoroughly cleaned and
disinfected. DO NOT USE ABRASIVE CLEANERS ON THIS HIGH-GLOSS ACRYLIC FINISH. Use a
non-abrasive cleaner and rinse THOROUGHLY after cleaning.
Fingernail polish remover can be used to remove labels from surface of tub.
Close the air controls to prevent excessive foaming. To close air controls turn knobs
clockwise.
Fill the tub to 2” above the highest jet with water
Add 2 teaspoons of low sudsing automatic dishwashing detergent along with no more
than 4 ounces of a household bleach to the water
Operate for 5 to 10 minutes
Drain the tub—fill it with water—operate for 5 minutes, then drain.
When using your whirlpool, fill it the way you would any conventional bathtub, but use
moderation in experimenting with small amounts of shampoo or soap products.
Avoid excessive foaming.
We do not recommend the use of bath oils or bubble baths in this
product. DO NOT START THE WHIRLPOOL PUMP UNTIL THE TUB IS FILLED WITH WATER.
1.
Fill the tub with the desired temperature water to approximately 2” above the highest jet.
2.
Turn on the whirlpool pump. This will start the whirlpool action.
3.
Turn off the pump to stop the whirlpool action.
4.
Drain and rinse the tub after use.
Another very important area to maintain is the door drain located at the bottom of
your door opening. You can see this drain only when the door is in the open position.
Important; Please be sure to keep it clean and free of debris at all times. To clean door drain
line use a can of compressed air (generally used on computers). Insert the air can tube into
the drain hole and depress the button on the top of the can.
