19
9. ERRORS AND REMEDIAL MEASURES
When an error occurs during counting, the Count
Display will flash the error code. Clear the error in
accordance with the following procedure.
Error Code
Cause of Error
Remedial Measures
Flashing of
displayed
number
Feeding Failure
When preset, the
number of counted
notes does not reach
the preset number.
Take out the note causing feeding failure from the Hopper
and reset it on the Hopper properly.
Put additional notes on the Hopper.
ASn
Notes are fed with a
excessive angle.
1. Take away the last note from the Stacker and make sure
that it is the same note as the others.
2. Depress “START/C” Key.
3. Recount all the notes taken away from the Stacker.
bi
100, 200 or 500 Euro
note was counted in
value mode.
(Only for J-720)
1. Check the last note on the Stacker.
2. If the last note on the Stacker is not accumulated to the
total amount, remove the note from the Stacker and
depress "START/C" key
3. When the last note on the Stacker is accumulated to the
total amount, depress Ten-key "8", "9" or "0"
corresponding to the denomination.
Cd 1
Cd 2
Color of note is
different than the Euro
note.
1. Display indicates ”LASt-XX”.
2. Remove the number of notes indicated by ‘XX’ from the
top of the notes in the Stacker. Make sure the notes are
OK or not.
3. Press the START/C key to continue the counting.
CHn
Excessively long
(shorter side) note or
overlapped notes are
fed.
1. Take away the last note from the Stacker and make sure
that it is the same note as the others.
2. Depress “START/C” Key.
3. Recount all the notes taken away from the Stacker.
When this error happens very often,
Readjust thickness level with Thickness Adjustment Dial.
CLL
Left Line Sensor is
dirty.
1. Clean the Line Sensor specified by Error Code.
If the Error is not cleared, take following measure.
Turn off the Length Size Check Function.
Open the Note Guide to the maximum position.
Count the notes several times for cleaning with placing notes
either side of Hopper according to the Error Code.
CLr
Right Line Sensor is
dirty.
CLt
The left / right line
sensor is dirty.
Summary of Contents for J-700 Series
Page 6: ...4 Notes...
Page 24: ...22 Notes...
