7
ASSEMBLY INSTRUCTIONS
4
Standard 20 lb. tank
4. Connect hose and regulator to cylinder.
The propane gas and cylinder are sold separately.
Use a standard 20 lb. propane cylinder only.
Use this heater only with a propane vapor withdrawal
supply system. See chapter 12 of the standard for
storage and handling of liquefied petroleum gas,
ANSI/NFPA 58 or CSA B149.1, Natural Gas and
Propane Installation Code. Your local library or fire
department should have this book.
Storage of an appliance indoors is permissible only if
the cylinder is disconnected and removed from the
appliance. A cylinder must be stored outdoors in a
well-ventilated area out of the reach of children. A
disconnected cylinder must have dust caps tightly
installed and must not be stored in a building, garage
or any other enclosed area. The maximum inlet gas
supply pressure: 250 psi, The minimum inlet gas supply pressure: 5 psi. is required for
purpose of input adjustment. The minimum hourly of 16000 Btu/hr is required input
rating for a heater at ratings less than full input rating. The pressure regulator and
hose assembly supplied with the appliance must be used. The installation
must conform with local codes, or in the absence of local codes,with
national fuel gas code, ANSI Z223.1/NFPA54, natural gas and
propane Installation Code, CSA B149.1, or propane storage
and handling code, B149.2.
3
3. Propane Only-Proper Hose Connection.
WARNING! Ensure the hose does not contact
any high temperature surfaces, or it may melt
and leak causing a fire.
