Turn the hard disk drive/interface board assembly right side up and place it into the
bottom half of the Kazan enclosure. (The bottom half is the portion with the front
bezel attached.)
Fit the rear plate into the slotted tracks at the rear of the enclosure.
Rear plate
Slotted
track
2
Installation
Remove the Kazan interface board from the Kazan enclosure by unplugging the green
and black LED cable and unscrewing the rear plate. Place your hard disk drive and the
Kazan rear plate/interface board assembly upside down on a flat surface.
Fasten the hard disk drive bracket to the hard disk drive with four screws in the holes
shown.
Firmly attach the power and ribbon cable connectors on the interface board to the
hard disk drive.
Power
connector
Ribbon
cable
connector
