Installation and Setup
BLUEPOD TECHNICAL SERVICE
Tel: 1800 800 255 Email: technical@bluepod.com.au
Copyright Bluepod Coffee Co Pty Ltd
Page 11 of 12
LB3200 Colibri
DATE OF ISSUE: 27/01/2011
Problem Solving
LCD display shows “out of order” -
Press any button on the front of the machine, after a short
delay, the LCD will display a failure reading. If the error is not reflected on the list below, visit
our support website
www.bluepod.com.au/support
or call 1800 800 255.
Machine display reads "Coffee Sel Out"
- Ensure there are pods in the pod hopper. If it is
empty, replenish as necessary. If pods are present in hopper, there may be a crushed pod at the
base of the hopper. Open the main machine door, lift the hopper body directly upwards. Check
the clear round carousel for crushed pods then replace hopper. Ensure the round white plastic
pod rotator at bottom of hopper is engaged with the drive spindle.
Machine displays “Waste cont full”
‘Waste Cont full’ is
NOT
a malfunction or error. The machine simply requires emptying.
If your machine has a base cabinet:
1. use the round key, open the lower door.
2. Empty/clean the upper used pod container and lower waste water container.
3. Ensure both waste water pipe and float/chain are in the waste container
4. The machine will reset and is ready to use
If your machine is counter/benchtop mounted:
1. Open the machine, insert the yellow service key.
2. Wait for the display to read ‘Ready for use’.
3. Remove both the front drip tray and rear waste container.
4. Empty and clean both.
5.
DO NOT
replace immediately. Wait until LCD display reads ‘Insert tray’.
6. Once the message appears, insert rear waste container and front drip tray
7. Remove yellow key, close and lock the door.
The machine is now be reset and will vend 50 pods. Then the message will reappear and this
procedure will need to be followed once again.
