INSTRUCTION MANUAL
•
2
SAFETY INSTRUCTIONS
Please observe the following safety instructions to avoid personal injury and property loss.
OPERATING PROCEDURES
The Lavex Janitorial line of commercial air movers is designed to efficiently and effectively
dry carpets and floors, and ventilate, extract and circulate air. Be sure to follow all instructions
below to ensure safe and effective use.
1) Ensure that the unit is on a stable, level surface, and remains stationary while in use.
2) Plug the blower into a grounded outlet with the correct voltage and amperage. Ensure
that the unit is plugged into a grounded outlet with voltage and wattage outputs that
correspond with the unit’s specifications. For maximum protection against electrical shock,
ALWAYS use a circuit that is protected by a ground fault circuit interrupter. If you are unsure
about the outlet, check with a qualified electrician.
3) Ensure that the dial is turned to your desired speed setting before turning the unit on.
Do not move or adjust blower while in operation
Keep this unit out of the reach of children
Do not alter or modify your blower in any way. Only authorized Lavex Janitorial
replacement parts can be used. Use of any unauthorized parts could cause hazards and
void the unit’s warranty
Always store unit in a clean, dry environment when not in use. Care should be taken
to prevent water from entering the unit’s motor. In the case that the unit’s motor does
become wet, ensure that the motor is dried thoroughly before use.
Do not allow water near or inside the unit while in use to avoid risk of electric shock.
Handle unit with care to avoid causing damage or personal injury.
Always operate the blower on a flat, level surface. Operating the unit where it could slip
or fall increases the risk of injury, fire, or electrical shock.
Never operate the blower without the factory-installed safety screens in place. This will
prevent liquids, gases, and other materials from entering the blower.
Do not use blower near combustible gas or flammable materials in order to avoid fire or
electrical hazards.
Do not attempt to disassemble or repair unit on your own. Instead, bring to the attention
of your distributor or a certified repair center. Never attempt to disassemble or repair unit
while blower is plugged in.
Prior to use, ensure the air intake and outlet are free of obstructions to prevent the blower
from overheating and causing a shock or fire hazard.
1)
2)
3)
4)
5)
6)
7)
8)
9)
10)
11)