INSTRUCTION MANUAL
•
5
TROUBLESHOOTING
Problem
Possible Causes & Solutions
BLOWER DOES
NOT TURN ON
1) Switch not turned on - in this case, ensure that the knob is in the correct
position to turn the unit on
2) Circuit breaker or GFCI has tripped - press ‘reset button before attempting to
turn the unit on
3) Cord or wires are loose or damaged - Inspect to ensure that cords and wires
are tight and free of damage
4) Faulty switch - Contact your distributor if inside warranty period
BLOWER STARTS
AND THEN TURNS
OFF
1) Obstructed inlet/outlet - remove obstructions and ensure that both inlet and
outlets are clear before use.
2) Faulty motor - Contact your distributor if inside warranty period
BLOWER
VIBRATES
1) Motor shaft is bent - Contact your distributor if inside warranty period
2) Fan blade is bent - Contact your distributor if inside warranty period
3) Excessive dirt built up on fan blade - Clean blade and ensure blade housing
is free of dust and dirt before use
BLOWER MAKES
SCRAPING NOISES
1) Damaged housing - Inspect housing for warps or dents. If housing is rubbing
against blade, contact your distributor.
MOTOR MAKES
NOISE, BUT
BLOWER WON’T
TURN ON
1) Damaged/faulty motor or motor shaft - Contact your distibutor if inside
warranty period
2) Motor shaft screw holding fan blade is loose - tighten
For problems not listed above, contact your distributor.
