Superabrasive User Manual Original Language Lavina® 14E May 12, 2020
15
4.3 TOOL MOUNTING
The Lavina® 14E uses tool holder A64. With this new holder every one of our tools uses the “Quickchange” connection.
To mount tools, begin by unlocking the
butterfly
with the provided
key.
Remove the
security plate
and set it aside. Load the
desired tool as shown below, insert the
security plate
and lock it in place again by rotating the
butterfly
with the
key.
For some new tools, the
security plate
must be removed, as they don’t need a locking system. For all others, however, always
make sure
the security plate
is installed and tools are securely locked!
In the Lavina 14E the holder is initially mounted with 6 buffers.
When using the machine primarily around corners and near walls, we recommend keeping the 6 buffers as they make the
machine cut much more aggressively. To reduce the aggressiveness with which the machine cuts, remove 3 of the buffers.
For more information on buffer installation refer to section 8.3.
WARNING!
Mount tools only after ensuring that there is enough diamond bond material left. Be sure that the plates are always clean
before mounting.
4.3 STARTING THE MACHINE
Follow the directions in the chapter on Safety Devices
and Safety Instructions.
Coonect the machine to a vacuum unit. Make sure the
EMERGENCY STOP
button is released
.
Check the
RPM
CONTROL KNOB
and ensure that it is set to the desired
working speed based on the tools being used. Holding the
machine firmly, rotate the
ON/OFF
switch to the right
and push down on the handlebars at the same time to
start the machine. Pushing down on the handlebars, lifts
the head of the machine, helping the machine get up to
speed.
Summary of Contents for ELITE Series
Page 2: ...Superabrasive User Manual Original Language Lavina 14E May 12 2020 2...
Page 21: ...Superabrasive User Manual Original Language Lavina 14E May 12 2020 21...
Page 27: ...Superabrasive User Manual Original Language Lavina 14E May 12 2020 27 11 3 CARRIAGE...
Page 29: ...Superabrasive User Manual Original Language Lavina 14E May 12 2020 29 11 4 HANDLEBAR ASSEMBLY...
