3
INSTALLATION
The
CleanJet
should be installed where it is easily connected to the water supply.
Before mounting, check that all valves can be easily operated and exposed surfaces are accessible for cleaning
and routine maintenance.
Positioning and drilling plans:
Remove the
CleanJet
from the box and remove the cover by removing
the screws at the top and pressing the release tabs. You can now access
to the mounting holes (located on the rear panel). Mount the
CleanJet
on
the wall using the supplied anchors, screws and washers.
The versatility of the
CleanJet
allows the hose bracket to be installed as
an integrated part of the unit or mounted independently as pictured
below.
Figure 2 – Drilling plans and positioning
GROUND
700 mm (27,
56’’)
700 mm (27,
56’’)
248.9 mm
(9,
8’’)
177.8 mm
(7,
0’’)
198.1 mm
(7,
8’’)
78.7 mm
(3,
1’’)
PACKAGE CONTENTS:
1.
CleanJet System
2.
Suction hose 1.83m / 6ft (1 roll for each product)
3.
Hose bracket
4.
Complete installation kit:
- Water inlet elbow fitting ¾” GHT
- Plastic hose clamps (2 for each product)
- 15 metering tips (1 bag for each product)
- 4 ultra-lean tips (1 bag for each product)
- Foot valve (1 for each product)
- Ceramic weight (1 for each product)
- Suction elbow (1 for each product)
- Wall anchors (3 pcs)
- Screws (3 pcs)
- Washers (3 pcs)
