36
CHAPTER 11 – STARTING AND STOPPING
STARTING THE MACHINE, IT IS INDISPENSABLE TO HAVE READ THE PREVIOUS
CHAPTERS.
SPECIFIC SEQUENCE FOR MODELS WITH ENDOTHERMIC ENGINES
Consult the attached motor instructions booklet previous.
•
STARTING:
1. When the engine is cold, pull the spring-loaded STARTER lever outwards to the CLOSED position (CHOKE
SHUT).
2. Move the accelerator lever upwards from the SLOW position towards the FAST position;
3 . Pull lightly on the starting handle until you feel some resistance, then pull forcefully . Gently push the
starting handle back into position . Do not allow the knob of the cord to return forcefully and strike the
engine . Slowly move it back into position to prevent damage to the start-up .
4. Push the starter spring lever to the OPEN position (CHOKE OPEN) as soon as the engine has warmed up
enough to run smoothly
•
RUNNING:
1 . Once the engine is running return the accelerator lever to the low speed position “ SLOW “ and warm the
engine for a few minutes . Gradually move the accelerator lever towards the high speed position until the
required speed is reached .
IMPORTANT: If there is no need to keep the engine accelerating, slow it down gradually
by moving the accelerator lever to the idle running speed: this will reduce fuel
consumption and prolong the engine life.
•
TURNING THE ENGINE OFF:
1 . Move the accelerator lever to Minimum and keep the engine running for 30/40 seconds before turning it
off .
2 . Lower the lever fully down to the “STOP” position . The engine will stop .
3 . Once it has stopped, lift the accelerator lever slightly .
SPECIFIC SEQUENCE FOR BATTERY POWERED MODELS
•
START:
1 . Turn the key in the clockwise direction Detail 3 Fig. 6
.
•
STOP:
1 . Turn the key in the anticlockwise direction, Detail 3 Fig. 6
.
Summary of Contents for CSW 568 BT
