34
CHAPTER 7 - MACHINE DESCRIPTION
SAFETY GUARDS
As illustrated in Fig . 4 it is possible to
see the safety guards that must be intact
and accurately installed . It is not possible
to use the machine with one or more
missing or damaged guards .
1) Casing to close the filter
compartment
2) Man on board safety micron
(under seat)
3) Flashing light
4) Motor hood
5) Bumper wheel
6) Side broom casing
7) Traction motor casing
8) Central broom guard side
9) RT and LT side
CENTRAL AND SIDE BROOM
The side broom, Detail 1 Fig. 5, acts as
a conveyor for the dust and debris and
is used exclusively for cleaning edges,
corners, profiles, and must be disabled
(raised) once they have been cleaned
to avoid lifting unnecessary dust and
because the side broom cleans less
thoroughly than the central broom .
The central broom Detail 2 Fig. 5 is
the main part of the machine, which
allows dust and debris to be loaded
into the debris hopper; it is possible to
request different bristle stiffness and
type, depending on the type of material
will be collected or the type of floor; the
height can be adjusted as the bristle
length wears down (see “CHAPTER 13 -
ROUTINE MAINTENANCE”) .
IMPORTANT: do not collect cords, wires, packaging straps, sticks, etc that are longer
than 25 cm as they may get twisted around the central and side brooms and damage
them.
Summary of Contents for SWL R 1100 DT
Page 188: ...cod 7 700 0577 00 05 2022...
