Avoid to point the water jet to the machine
or to any electric part.
•
WARNING: Use of any electrical machine
implies compliance with certain fundamental
rules. In particular:
- NEVER EVER TOUCH THE MACHINE WITH
WET HANDS OR BARE FEET.
- NEVER PULL THE POWER SUPPLY CABLE OR
MACHINE IN ORDER TO DISCONNECT THE
PLUG FROM THE SOCKET.
- IF DURING FUNCTIONING THE POWER
SUPPLY RUNS OUT, FOR SAFETY REASONS,
TURN THE MACHINE OFF.
> STABILITY
•
WARNING:
The machine must be always kept
on horizontal bases, in a safe and stable way.
> WATER SUPPLY
· Connect a supply hose to the water
outlet of the Hipressurecleaner.
WARNING: (symbol) machine not
suitable for connection to the potable water
mains.
The cleaner can only be connected to the wa-
ter mains if the water mains is separated by a
backflow preventer.
Make sure that the hose is at least Ø 13mm-1/2
inch and that it is reinforced.
•
WARNING: Water that has flown through
backflow preventers is considered to be
nonpotable.
IMPORTANT: Only clean or filtered water
should be used for intake. The delivery of
the water intake tap should be equal to the
double of the maximum pump range.
- Minimum delivery rate: 11 l/ min.
- Maximum delivery rate: 21 l/ min.
- Maximum intake water temperature: 40°C
- Maximum inlet water pressure: 1
12 Mpa (120 bar) - max 20 MPa (max 200
bar)
Water supply from the water main
· Connect a supply hose (not included) to
the water inlet of the unit and to the water
supply.
· Open the water supply.
> ELECTRICITY SUPPLY
- The appliance’s electrical connection must
comply with the IEC 60364-1 standard.
IMPORTANT: Before connecting the
appliance, make sure that the nameplate
data are the same as those of the electrical
mains and that the socket is protected by a
differential security breaker with tripping
sensitivity below 0.03 A - 30 ms.
- If the appliance’s plug is not compatible with
the socket, have the socket replaced with
another of suitable type by professionally
qualified staff.
-
Never use the appliance in ambient
temperatures below 0° C if it is equipped
with a PVC (H VV-F) cable.
•
XY WARNING: Inadequate extension cords
can be dangerous.
•
XJ WARNING: If an extension cord is used,
the plug and socket must be of watertight
construction.
Information for supply may also be obtained
from the plug manufacturer.
230-240V
400-415V
3G 2,5 mm2
4G 2,5 mm2
max 20 m
max 30 m
EN
16
Summary of Contents for Vulcano
