EN-6
Assembly
Handle
Assembly
1.
Loosen handle knobs and lift top handle half in
an arc until handle halves are in line and nest
together (Fig. 1).
Note:
Use care to prevent pinching or
stretching of cables.
1385
2
1
Figure 1
1.
Knob
2.
Top handle half
2.
Tighten knobs securely.
3.
Rotate handle toward rear of mower until it
snaps into stops in handle brackets.
Handle Height
The handle has two height positions–high and low
(Fig. 2). Select a handle height position that is most
comfortable for you.
1.
To change handle height, squeeze bottom handle
section together and align holes over pins inside
handle brackets.
1384
1
2
Figure 2
1.
Low setting
2.
Highsetting
Blade Control Cable
Attach blade control cable (if not attached on your
mower).
1.
With bail forward (released), slide control cable
onto threaded stud on right side of bail (Fig. 3).
2.
Using a wrench, secure with acorn nut supplied
in owner’s package (Fig. 3).
1383
2
1
3
Figure 3
1.
Blade control cable
2.
Acorn nut
3.
Stud
