18
Observe the following points in particular:
•
Check the cutting tools for damage and wear.
•
Correct installation of the cutting head
•
Easy movement of all switches
•
Secure sit of the spark plug connector. If the connector is loose, sparks can be
formed and thus ignite any leaking fuel
•
Ensure the handles are clean in order to be able to guide the equipment safely.
•
All safety and protective devices must be properly installed and in place before
the equipment can be started.
The Nylon head must be able to run freely.
Before starting the equipment, ensure that the mowing head is sitting correctly and that the Nylon
parts are
HOOKING AND UNHOOKING OF HARNESS
(Picture 9, p 19):
Use the safety harness.
Adjust the lenght and the width of the harness, so to obtain a confortable position.
The harness is equipped by a quick release system.
To remove it, simply pull the plate from the middle to the outside.
Fix the hook of the harness at the fixing ring provided on the shaft.
free.
Warning!
If there is any doubt, seek help with the operation of this equipment from a specialist
in an authorised service centre.
Warning!
Before initial operation of the equipment, it must be checked that the condition
is safe for operation. If there is any doubt, do not start the equipment.
Initial Operation
OPERATION