Figure 16
1.
Jack stand
WARNING
Mechanical or hydraulic jacks may fail to support
machine and cause a serious injury.
•
Use jack stands when supporting machine.
•
Do not use hydraulic jacks.
Lubrication
Greasing the Center Tines
Service Interval:
Before each use or daily
1. Raise the tines, stop the machine, stop the engine,
and disconnect the spark plug wire.
2. Remove the rear access panel; refer to
Accessing the Tines (page 13)
3. Manually rotate the 2 center tine assemblies until you
can see the grease fittings (Figure 17).
Figure 17
4. Wipe the grease fittings with a clean rag.
5. Install a grease gun onto the fitting and gently apply 2
or 3 pumps of #2 multi-purpose lithium base grease.
Important:
Excessive grease pressure may
damage the seals.
Lubricating the Drive Chains
Service Interval:
Every 25 hours
1. Raise the tines, stop the machine, stop the engine,
and disconnect the spark plug wire.
2. Raise the front of the machine to gain access to the
chains (Figure 18) and block it in place.
CAUTION
If you do not securely block the up the front
of the machine, the machine could fall on you
during service, injuring you.
Ensure that you place a jack-stand or block
under the front of the machine to hold it up
securely.
14
